COMPONENTS

POWER UNIT

Contemporary elevator systems utilize the most trouble-free and easily serviced components available. The submersible power units built by Canton Elevator are defined by that criteria and use only the highest grade materials available. There are no external pipes or fittings to leak and no belts to break, stretch or adjust.

• Furnished with silencer.
• Built-in pressure gauge to assist in installation and service.
• Integral controller mounted to front of unit and motor starter/valve coils are prewired for quick and easy installation.
• Isolation mounting pads are included.
• Maximum nominal size of power unit is 48" W x 33¾" D x 42" H overall with controller.
• For installation where machine room door width is less than 36", controller and motor/starter panel can be removed. Maximum depth of power unit is then 26¾".
• Basic Tradesman package is designed to operate on 208/220-240V/3 PH/60 HZ power supply. Can be furnished to operate on other voltages.
• Threaded oil line and fittings, and wiring materials are furnished for an adjacent machine room at side or rear of shaft at lowest landing.

CONTROLLER

The microcomputer-based controller provided as a standard with every Canton Elevator Tradesman system incorporates the latest technologies in the industry. The most important features include: on board diagnostics, which require no additional test equipment to maintain or troubleshoot; permanent display of all calls, car position, and direction along with key modes of operation and condition codes; and built-in protection timers that can save your hydraulics, pump and door motors from damage and unnecessary wear. Simplicity, combined with ease of installation and "at-a-glance" service indicators, help to ensure your system’s reliability while keeping maintenance costs to a minimum. Provision is made for car traveling lantern with handicap gong, independent service, low oil control.

Optional features available at added cost:

• Phase I & II fire service - per code requirements
• Phase reverse relay
• Access switch provision
• Hall lantern and gongs
• Mass EMT provision
• Door nudging
• Wye-Delta starting system
• Interfaceto rescuvator or emergency power system
• CSA label

MAGNETIC TAPE LANDING SYSTEM

This cartop mounted system provides accurate performance for deceleration, stopping, leveling, and access zoning. This unit eliminates the need for vanes and switches.

RAIL BRACKETS

Reduces installation time by allowing complete rail adjustment in all directions.

GUIDE SHOES

• Removable nylon swivel insert
• No bearings or springs to wear out or break
• Easy to adjust

JACK

Hole type jacks include factory applied corrosion preventative coating. One piece buffer/pit support plate design reduces installation time. Leveling bolts included for quick and easy alignment. Isolated platen plate. Bolt-on heads feature one piece packing and wiper ring for ease of replacement. Spare packing seal is included with each shipment.